Most Popular
- Measuring multi-core performance, power efficiency ( 12/07/10)
- Implementing synchronous rectifiers with digital isolators ( 17/06/10)
- Design and application guide for SG6859D ( 15/01/10)
- CFL 13W demo PCB with high-voltage IC for lamp-ballast ( 21/01/09)
- New power supply IC designs required for today¡¯s cars ( 11/04/07)
- IGBT tutorial: Selection ( 08/03/07)
- Adjustable Latching Output Over Current Circuit ( 20/06/03)
Hot Picks
- Build reliable Zigbee-based solutions
- Rail-to-rail amp improves input offset accuracy
- Gear up for the shift to 42V systems
- Sneak peek at the future of CMOS imaging
- Enterprise-embedded union calls for single tech
- Implement low-power 65nm FPGA designs
- Use TMU to measure AC signal's DC offset
- Simulate embedded hardware acceleration
- Address content, features in PMP development
- Data logging goes wireless
Application Notes (Sorted By Date)
-
Avoiding MOSFET driver overstress
(30/07/10)
[ Power Conversion/Management ]
-
Power supply design for the ADS41xx (29/07/10)
[ Supplies & Accessories ]
-
3kW fixed-off-time (FOT) power factor correction (28/07/10)
[ Power Conversion/Management ]
-
Digital peak current mode control with slope compensation using the TMS320F2803x (27/07/10)
[ Supplies & Accessories ]
-
UCC28070 300W interleaved PFC pre-regulator design review (26/07/10)
[ Power Conversion/Management ]
-
Variable resistor and temperature-indexed LUT compensate for regulator output (23/07/10)
[ Supplies & Accessories ]
-
Ways to optimise the performance of a difference amplifier (20/07/10)
[ Power Conversion/Management ]
-
A single-phase energy meter with capacitive power supply and shunts (19/07/10)
[ Power Test ]
-
Replacing output clamping op amps with input clamping amps (16/07/10)
[ Power Conversion/Management ]
-
3.6V to 6V input, 3.3V output, tiny and high-efficiency DC/DC converter (15/07/10)
[ Power Conversion/Management ]
-
A guide to voltage translation with TXS-type translators (14/07/10)
[ Power Conversion/Management ]
-
Base station subassemblies: addressing DC power test challenges (13/07/10)
[ Power Test ]
-
Discover the benefits of auto ramp and scan functions (12/07/10)
[ Power Test ]
-
Simulating power supply interrupts (09/07/10)
[ Portable Power ]
-
Dynamic current profiling (08/07/10)
[ Power Conversion/Management ]
-
Ultra-small UCSP devices improve battery management in portable applications (07/07/10)
[ Portable Power ]
-
GMSL line-fault detection (06/07/10)
[ Power Conversion/Management ]
-
112W boost driver for long strings of LEDs using all ceramic capacitors (05/07/10)
[ Supplies & Accessories ]
-
Discrete circuit protects Li-ion battery charger (02/07/10)
[ Power Conversion/Management ]
-
Understanding temperature specifications: an introduction (01/07/10)
[ Supplies & Accessories ]
-
Driving 3-phase brushless motors (30/06/10)
[ Industrial ]
-
Bridge mode operation of power op amps (29/06/10)
[ Power Conversion/Management ]
-
Stability for power operational amplifiers (28/06/10)
[ Power Conversion/Management ]
-
Wideband, low distortion techniques (25/06/10)
[ Power Conversion/Management ]
-
SOA advantages of MOSFETs (24/06/10)
[ Power Conversion/Management ]
-
Thermal techniques (23/06/10)
[ Power Conversion/Management ]
-
Power amp output impedance (22/06/10)
[ Power Conversion/Management ]
-
Characterising the I-V curve of solar cells and modules (21/06/10)
[ Green Tech ]
-
Solar cell and module testing (18/06/10)
[ Green Tech ]
-
Reference design: wide range 200W L6599-based HB LLC resonant converter for LCD TV, flat panels (17/06/10)
[ Power Conversion/Management ]
-
L6565 quasi-resonant controller (16/06/10)
[ Power Conversion/Management ]
-
VIPower: 30W SMPS using VIPer50A-E (15/06/10)
[ Supplies & Accessories ]
-
VIPower: 108W power supply using VIPer100A-E (14/06/10)
[ Supplies & Accessories ]
-
SupIRBuck MCM Power QFN (PQFN) board mount (11/06/10)
[ Power Conversion/Management ]
-
IRS21091 and IR21091 comparison (10/06/10)
[ Power Conversion/Management ]
-
IRS20955S and IRS20955S comparison (09/06/10)
[ Power Conversion/Management ]
-
IRS212 (7,8,71) and IR212 (7,8,71) comparison (08/06/10)
[ Supplies & Accessories ]
-
Discrete design of a low-cost isolated 3.3V to 5V DC/DC converter (07/06/10)
[ Power Conversion/Management ]
-
Bootstrap network analysis: focusing on the integrated bootstrap functionality (04/06/10)
[ Supplies & Accessories ]
-
SupIRBuck MCM power QFN (PQFN) inspection (03/06/10)
[ Power Conversion/Management ]
-
DC output errors in a fully-differential amplifier (02/06/10)
[ Power Conversion/Management ]
-
How to successfully apply low dropout regulators (01/06/10)
[ Power Conversion/Management ]
-
TPS54620 parallel operation (31/05/10)
[ Power Conversion/Management ]
-
Creating a split-rail power supply with a wide input voltage buck regulator (28/05/10)
[ Supplies & Accessories ]
-
Design consideration for BCM PFC using FAN7930 (27/05/10)
[ Power Conversion/Management ]
-
How to design a transition-mode PFC pre-regulator with the L6563S and L6563H (26/05/10)
[ Supplies & Accessories ]
-
Solution for designing a fixed off-time controlled PFC pre-regulator with the L6564 (25/05/10)
[ Power Conversion/Management ]
-
Programming the TMS320VC5509 ADC peripheral (24/05/10)
[ Power Conversion/Management ]
-
Power reference design for the TMS320C6472, 12Vin DC/DC controllers and LDOs (1x C6472) (21/05/10)
[ Power Conversion/Management ]
-
AM3517/05 power reference design 3.6V to 6.3V input, high-efficiency, integrated 5-output PMIC (20/05/10)
[ Power Conversion/Management ]
961 records, page 1 of 20
|
||||||||
|
||||||||
|
||||||||
Design Notes
